Letter A

Abalakov thread

This is an artificially created thread in the ice. You make it by drilling two holes, or tunnels, using an ice screw (which does not stay in the ice; it only serves as a tool). Most commonly, you create an Abalakov thread as an abseil anchor in situations where you cannot build other, better protection in the terrain (and at the same time, you are not willing to leave a screw and karabiner behind). In extreme situations, you can also use an Abalakov thread for a belay anchor, but then you must use a thicker sling with a sufficient load capacity. You could also use it as running protection, but it is not very practical, as making the thread is too time-consuming.

You must only make an Abalakov thread in hard, homogeneous ice so that it is strong enough. For example, porous, overly crystalline ice is not suitable. The drilled holes and the ice surface must form an angle of approx. 60° to each other. The holes should be at least 15 cm long. As a result of drilling, the ice must not crack in the place where you are creating the thread; above all, the resulting ice bridge must remain intact. This is sometimes a problem; especially in severe frosts, the ice is very brittle and breaks. On the other hand, in high-quality ice, an Abalakov thread can hold up to 11 kN.

Back to glossary